EV Charger Installation in Los Gatos, CA

Not always. Many Belwood and Blossom Manor ranch homes already have enough capacity, and where they don't, a load-management device can sometimes let the charger share the existing service. We run a load calculation first and tell you honestly whether you need an upgrade, a load manager, or neither, before recommending the more expensive route.

Yes. Long runs are routine on hillside properties in the Los Gatos Mountains and Shannon Hills. We run conduit cleanly from the panel to your parking area, weatherproofing any outdoor sections, and size the wire correctly for the distance so there's no voltage drop. We factor the run length into the quote up front.

Often, but the older Almond Grove and downtown homes frequently have 100-amp service or a fuse box, so we check capacity before anything else. Sometimes the charger fits with a load manager, and sometimes it's the nudge a 1910 home needed toward a panel upgrade anyway. We give you the straight picture rather than assuming an upgrade is required.

It depends on your vehicle and how you want to manage charging. Tesla owners usually go with a Wall Connector, while a universal NEMA 14-50 or a ChargePoint unit suits mixed or future vehicles. We install all of them and can talk through the tradeoffs during the load check so you pick what fits your household.

Yes. A new dedicated 240V circuit requires an electrical permit and inspection from the Town of Los Gatos, or from Santa Clara County if your home is in an unincorporated hillside area. We pull the permit and close out the inspection so the circuit is documented, which matters for safety and for resale.

The Town's EV submittal checklist requires NEC Article 220 load calculations for any service under 200 amps. A Level 2 charger is a continuous load, and on the 100 amp services common in Belwood, Blossom Manor and the pre-1941 homes downtown, the calculation decides whether the charger fits as is, needs a load management device, or needs a larger service.

The Town's installation requirements put the coupling at least 18 inches above the floor indoors and 24 inches above grade outdoors, with clear working space of 30 inches wide, 3 feet deep and 6 feet 6 inches high at the equipment, and a separate disconnect in a readily accessible location for any unit over 60 amps.